Originally Posted by
ccierscisco
TS2:
Q1: access-list you need to do deny
access-list 111 deny udp 10.4.0.0 0.0.255.255 host 224.0.0.102 eq 1985
access-list 111 permit tcp 10.4.0.0 0.0.255.255 any eq 666
access-list 111 deny ip any any
Q2: OSPF cost change on SW111
Q3 R23 ospf process was different in loopback and metric R22/R23
Q4 : in question Dont change BGP attribute and I had changed ospf cost of R20 loopback so that R21 router selected
Q5: R60
interface Tunnel0
ip address 10.100.0.60 255.255.255.0
Q6:
SW111(config)#int vlan 2001
SW111(config-if)#ospfv3 65001 ipv6 area 0
Q7:
R10
router bgp 65001
redistribute ospf 65001
R10(config)#router ospf 65001
R10(config-router)#distance ospf external 111 -> default 110 but on config 19
R3 looback ospf process was not correct after change correcting ospf process bgp came up
Q8:
ip dhcp relay information trusted
arp inspection trust
Q9//
ip ospf network point-to-multipoint
Q10:
ip nat outside source static 201.99.70.2 201.99.25.70
R24